SOLVING PROBLEM :
To Solve the reflectiveness of the Dome I have decide to PAINT the Dome nut
Therefore it would be reflective and detectable for 123D Catch to be RECOGNISABLE
THEN IMAGES BEEN TAKEN AND PUT IN 123D MAKE TO GENERATE A 3D MODEL
FINALISING :
RESULTs are unsuccessful as part of the 3D model are missing
PROBLEM :
Dome are much detectable by 123D MAKE
However part are missing are cause by paint on the Dome Nut are EVENLY SPREAD Through
Therefore it is difficult for 123D MAKE to detect the DIFFERENT SIDES of the Dome Nut and allow 123D MAKE to detect and locks in place of each images together to generate a complete model
No comments:
Post a Comment